☩DIY☩ Burned Wood Jewelry Display/Key Hook

Things you need for this DIY:

✝ driftwood

✝ screw in hooks

✝ soldering iron

✝ drill

✝ 1/8 & 1/4 drill bits

✝ wood glue

✝ ruler

✝ pen

✝ screws or nails

 

Total time: 

1 hour

Don't have time to DIY? Buy these here!

DSC_0266.JPG

I need ten of these to properly organize my jewelry.

Start by burning your design into your driftwood. Straight lines and spots seem to be the easiest. Do I have to warn you to be super careful? Soldering irons are terrifyingly hot y'all. 

DSC_0196.JPG

Not too bad.

DSC_0210.JPG

Practice makes perfect!

DSC_0212.JPG

When you have a design you like, mark the bottom with dots one inch apart.

DSC_0222.JPG

Drill little holes where you marked.

DSC_0231.JPG

Then dab a little glue on your hooks and screw them into the wood.

DSC_0230.JPG

Use both drill bits to pre-drill holes with sinkholes for your screws or nails.

DSC_0266.JPG

Screw or nail into the wall and that's it! Get organized!

Don't have time to DIY? Buy these here!